Skip to main content
ITPrepCerts
Login
Exams Free Samples About Contact
Login Create an account

350-601 Implementing and Operating Cisco Data Center Core Technologies (DCCOR) & CCIE Data Center

  • Cisco
  • 4 free sample questions

About this exam

350-601 is the Cisco exam Implementing and Operating Cisco Data Center Core Technologies (DCCOR) & CCIE Data Center. Paid practice material for this exam is not available yet, but you can try its free sample questions.

Exam code
350-601
Vendor
Cisco
Practice questions
Not available yet
Free sample questions
4
Question bank last updated
Not available yet

Try 2 sample questions

Taken from the free sample set for 350-601.

Question 1

An engineer must configure OSPF routing on Cisco Nexus 9000 Series Switches. The IP subnet of the Eth 1/2 interface for both switches must be advertised via OSPF. However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interface Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected. Which configuration must be applied to both Nexus switches to meet these requirements?

  1. Option A:
    interface ethernet 1/2 passive-interface default
  2. Option B:
    Interface ethernet 1/2 Ip ospf network point-to-point
  3. Option C:
    interface ethernet 1/2 ip ospf passive-interface
  4. Option D:
    interface ethernet 1/2 no ip ospf passive-Interface
Show answer and explanation

Correct answer: C

The ip ospf passive-interface command is used to prevent OSPF adjacency and routing updates from being sent or received on a specific interface, while still advertising the interface subnet via OSPF. This command is useful for stub networks or loopback interfaces that do not need to form OSPF neighbor relationships. The other commands either enable OSPF adjacency by default, change the OSPF network type, or disable OSPF passive mode. Reference: Cisco Nexus 9000 Series NX-OS Unicast Routing Configuration Guide, Release 9.3(x) - Configuring OSPF [Cisco Nexus 9000 Series Switches], Configuring OSPF, Configuring OSPF Interfaces Cisco Nexus 9000 Series NX-OS Unicast Routing Configuration Guide, Release 9.3(x) - Configuring OSPF [Cisco Nexus 9000 Series Switches], Configuring OSPF, Configuring OSPF Passive Interfaces Cisco Nexus 9000 Series NX-OS Unicast Routing Configuration Guide, Release 9.3(x) - Configuring OSPF [Cisco Nexus 9000 Series Switches], Configuring OSPF, Configuring OSPF Network Types

Question 2

Which configuration statically assigns VSAN membership to a virtual Fibre Channel interface?  

  1. Option A:
    switch(config-vsan-cb>#
  2. Option B:
    vsan 100 bind interface fc 3/1
  3. Option C:
    switch# vsan 100 fc 3/1
  4. Option D:
    switch(config-vsan-db)# vsan 100 interface vfc 31
Show answer and explanation

Correct answer: B

The vsan bind interface command is used to statically assign VSAN membership to a virtual Fibre Channel interface. This command overrides the VSAN membership that is derived from the physical interface or the default VSAN. The other commands are either invalid or do not apply to virtual Fibre Channel interfaces. Reference: Cisco Nexus 9000 Series NX-OS Interfaces Configuration Guide, Release 9.3(x) - Configuring Virtual Fibre Channel Interfaces [Cisco Nexus 9000 Series Switches], Configuring Virtual Fibre Channel Interfaces, 
See all 4 free sample questions